HVAC Installation in Valdosta, GA
A new system here will heat from November through March and cool from May through October every year. Tell us about the house, and a licensed contractor who covers Lowndes County will get in touch.
Tell us about the job
It takes about a minute.
In Lowndes County, your system works almost all year
A home here needs heat or cooling eleven months out of the year. Summer stretches from May through October, six months of afternoons averaging 91°F, so the air conditioner carries the biggest part of the load. Winter is shorter, November through March, with nighttime lows averaging 41°F, but the furnace or heat pump still has to keep up on the coldest nights.
Most homes here heat with electricity, so a new system has to handle both jobs well, not just cooling. Wind events are common in this part of Georgia, and with them come power outages, so a system that comes back on by itself once power returns matters here.
- 5 months
- November through March, your system heats
- 6 months
- May through October, it cools
- 41°F
- the average winter night it heats against
- 91°F
- the average summer afternoon it cools against
NOAA nClimDiv, 1991–2020 normals
Georgia requires HVAC contractors to hold a state license.
The State Construction Industry Licensing Board tests contractors before it licenses them, and the license belongs to the contractor, not to any one job. So the same license that covers a repair down the street covers a full system installation in Lowndes County. Nothing about the size of the job changes what the state requires.
For an installation, that license is what stands behind the work, but it is not the only check on it. Putting in a new furnace or air conditioner in most cities and counties here also means a permit from the local building office, with an inspection once the work is finished. That inspection is where someone looks at what was actually installed, separate from whatever the license already says about the contractor.
Source: Georgia Secretary of State
- When should I replace my HVAC system?
- Once your system is old enough that repairs keep coming back, replacing it makes more sense than fixing it again. A furnace or air conditioner working hard for 11 months of the year here, between the cold snaps from November through March and the heat from May through October, wears faster than one that gets a break. If a contractor tells you the repair cost is climbing close to what a new system would run, or if your system is past the age where parts are getting hard to find, that is the point to stop patching it. Rising energy bills with no other explanation are another sign the system is losing efficiency.
- Should I replace my furnace and air conditioner at the same time?
- If both are old, replacing them together is usually the better move. A furnace and air conditioner installed at the same time are matched to work together, and a contractor can size both for your home in one visit instead of two. If only one has failed and the other is still young, there is no need to replace the working one early. A contractor looking at both systems can tell you whether they are close enough in age to make sense as a pair.
- What happens during an HVAC installation?
- A contractor removes the old equipment, sets the new furnace or air conditioner in place, and connects it to your ductwork, gas or electric lines, and thermostat. They check the refrigerant charge on the air conditioner side and test the furnace's ignition and airflow before calling it done. Ductwork gets inspected too, since a new system connected to leaky or undersized ducts will not perform the way it should. A contractor will walk through the specific steps and timeline for your house before starting the work.